.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
Kubota d722-e specsMeasure the piston pin bore S-13 1 Engine Body. Engine oil should have properties of API classification CF See page G-6. Remove the used battery. Reassemble the fuel filter. DIESEL ENGINE SM-E3B SERIES WSM Replacing Valve Guide When removing 1. Turn the crankshaft to set the crankpin of the third cylinder to the bottom dead center. Take the piston to an intermediate position.DIESEL ENGINE SM-E3B SERIES WSM Symptom Either White or Blue Exhaust Gas Is Observed Either Black or Dark Gray Exhaust Gas Is Observed Deficient Output Excessive Lubricant Oil Consumption Fuel Mixed into Lubricant Oil Water Mixed into Lubricant Oil Probable Cause Solution Reference Page Excessive engine oil Reduce to specified level G-7 Piston ring and cylinder worn or stuck Repair or replace S-43. Replace new intake air hose 1 and new clamp 2. Remove the piston rings using a piston ring tool. Teeth of pinion gear e. Fuel Feed Pump and Speed Control Plate for Energize to Run Type Engine Stop Solenoid Continued When reassembling 1.Loosen the air vent plug 3 of the fuel filter a few turns. Otherwise it may get deformed permanently. If the compression pressure is still less than the allowable limit. If there is any defect. If the measurement is less than the factory specification. Remove the injection pipes and glow plugs. If the measurement is less than the allowable limit. Thus see that the engine oil does not leak through the seal and be sure to read the oil level on the dipstick. Tilt A Allowable limit 1.Kubota d722-e specsApply a slight coat of oil onto the new cartridge gasket. Injection timing Serial No. Remove the nut and separate the plate 7.Refer to Diesel Engine Mechanism Workshop Manual Code No. S-29 3 Cylinder Head.